Stove Pipe

Stove pipe (connector pipe) that links your wood stove to the chimney. Shop single-wall and double-wall black stove pipe lengths, adjustable elbows, tees, adaptors, increasers and trim collars from DuraVent, Imperial, Heatfab and Buck Stove.

Skip to results list

Active filters:

126 items
Column grid
Column grid

Filter

Active filters:

Not sure what fits?

Answer a few questions about your chimney and appliance and we'll suggest a matching liner kit.

Find My Liner Kit
How to measure
  1. Measure the diameter of the stove's flue collar.
  2. Measure from the collar to the ceiling support or wall thimble and count the elbows you'll need.
  3. Check your stove manual for the clearances to walls and ceilings.

Still not sure? Contact us

Full Description

Stove pipe, also called connector pipe or flue pipe, is the visible black pipe that runs from a wood stove's flue collar to the chimney: either a ceiling support box where Class A chimney begins, or a wall thimble into a masonry or Class A chimney. It's designed to stay inside the room and is not made to pass through walls, ceilings or floors on its own.

Single-wall vs. double-wall stove pipe

  • Single-wall: one layer of steel. It radiates more heat into the room and costs less, but typically needs about 18 inches of clearance to combustibles.
  • Double-wall: an inner stainless and outer black wall with an air gap. It keeps flue gases hotter for better draft and often needs as little as 6 inches of clearance, depending on the listing.

Stove pipe parts in this collection

  • Straight lengths and telescoping (adjustable) lengths
  • Adjustable 45 and 90 degree elbows
  • Tees with clean-out caps for easy cleaning
  • Stove adaptors, oval-to-round adaptors and increasers
  • Trim collars, dampers and stove collars

Stove pipe installation basics

Keep runs short and as straight as possible, with no more than two 90 degree turns where practical. Install sections with the crimped end pointing down toward the stove so condensation and creosote run back into the firebox. Secure each joint with three sheet metal screws (for single-wall) and slope horizontal runs upward toward the chimney, typically at least 1/4 inch per foot. Always follow the stove and pipe manuals.

Frequently asked questions

What size stove pipe do I need?

Match the diameter of the stove's flue collar, usually 6 or 8 inches. Don't reduce the size below the collar. If the chimney is a different size, use the adaptor or increaser the stove and chimney manuals allow.

Which way does stove pipe go?

The crimped (male) end points down, toward the stove. That way liquid creosote and condensation drain back inside the pipe instead of leaking out of the joints.

Can stove pipe go through a wall or ceiling?

No. Use a listed wall thimble or ceiling support and switch to Class A chimney pipe where you pass through any wall, ceiling or roof. See Class A chimney pipe.

How far does stove pipe need to be from the wall?

Single-wall pipe commonly needs 18 inches of clearance to combustibles and double-wall often needs 6 inches, but the exact number is set by the pipe listing and stove manual. Listed heat shields can reduce clearances.

How often should stove pipe be replaced?

Inspect it every season. Replace any section that's rusted through, warped, dented or has loose seams. Single-wall pipe typically wears out faster than double-wall.

Not sure what fits your stove? Contact us with the stove model and the distance to your chimney connection.